The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.

• Sliding table with 4-foot stroke works with miter head, hold-down and fence to accomodate everything from multiple end cuts to tenons
• Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
• Large table with built-in slider with room for stock feeder
• 7" vertical spindle travel allows stacked tooling
• Spindle tilts negative 5 deg to positive 45 deg for increased versatility
• Large diameter multiple table inserts accomodate virtually any size cutter
• Five spindle speeds in forward and reverse with lighted indicator

Table Travel (In.)	49-1/4
Digital Readouts
Prewired Voltage (V.)	230
Wiring Remarks
Electrical Controls	Yes
Spindle Size Under Nut (In.)	3/4 (3-1/2), 1 (6-1/4), 1-1/4 (6-1/4)
Motor Phase	3
Maximum Diameter Cutter Above Table (In.)	12
Router Bit Collet Included	1/4, 1/2
Dust Collection Minimum CFM Required (CFM)	800
Style (Type)	Shaper
Table Insert Opening Diameter (In.)
Maximum Spindle Diameter (In.)	1-1/4
Spindles Included
Reversible	Yes
Table Opening Diameter (In.)
Maximum Diameter Cutter Below Table (In.)	9
Spindle Speed (RPM)	3,000, 4,000, 6,000, 8,000, 10,000
Table Size (In.)	51-1/2 x 33-1/2
Table T-Slot (In.)
Spindle Travel (In.)	7
Table Inserts (In.)	3: One Tilting, Two Straight
Fence Size (L x H) (In.)	46 x 5
Table Height from Floor (In.)
Motor Power (HP)	7-1/2
Fence Travel (Major and Minor) (In.)	5-3/8, 3-5/8
Motor Voltage (V.)	230, 460
Motor Current (Amps)
Dust Port Outside Diameter (In.)	5
Recommended Circuit Size (Amps.)
Sliding Table Size (In.)	11-1/4 x 51-1/4