Industrial Thin Kerf Fine Finish Crosscut Blades

Crosscutting Blades For Fine Finish With Underpowered Saws

This Perma-SHIELD coated blade gives life to underpowered saws and produces smooth crosscuts in hardwoods, softwoods and moldings. Coated blades pull 1/3 less on the saw, which translates into 33% more cutting power. Thin kerf blades remove less material than standard carbide blades, thus requiring less horsepower to produce equally good results.

- Thin Kerf reduces waste and feeds easier

- Positive Hook Angles produce a smoother cut and allow for a faster feed rate

If you experience burning on one side of the cut you should check and adjust the saw's alignment.

Consult your saw owner's manual for alignment instructions.

Freud Perma-Shield Blade: LU88R010

Diameter: 10 Inches

Arbor: 5/8 Inches

Kerf: 0.09

Plate: 0.071

Hook Angle: 15 Degree Hook