Parallel Edge Guide enables guided parallel cutting with the TS 75 Plunge Cut Saw. Can be used for parallel rip cutting with the TS saw independent of the FS guide rails. Attaches to both sides of the saw for short side or broad side cuts. Rip capacity from the blade side up to 11 13/16in (300mm) and on the motor side up to 3 3/4in (95mm).

• Can be used on both sides of the saw for short side and broad side cuts
• Enables parallel cutting when using the TS saw independent of the FS guide rails.
• Sturdy aluminum and steel contruction.
• Comes with through bolts and clamp for quick set up.